Simulating a design

This shows you how to simulate the circuit from Creating a design.

Place probes

To run a simulation, you must place at least one probe.

1. Drag a voltage probe from the palette and place as shown below. 
   
   
   
2. Place a second probe.
   
   
   

Select and run simulation

1. Select Transient from the toolbar.
   
   
   
2. Tap  in the toolbar. 
   For transient simulation, the view switches to the grapher. 
   
   
3. Tap  in the toolbar to open the configuration pane. 
   
   You can also double-tap on the grapher.
   
   
4. Use the Plots and Axes sections to manipulate the grapher as desired.
   Refer to Transient simulation for details.
   
5. Switch the simulation type to AC Sweep and tap .
   
   Available settings in the configuration pane have changed.
   Refer to AC sweep for details.